A1 PressureJet System Pvt. Ltd.
Sandblasting, Sand Blast, Wet Blast
Pressure jet has achieved tremendous success on a new feature of Water sandblasting equipments.There are a wide variety of surface preparation methods available, such as solvent cleaning, power-tool cleaning, dry sand blasting etc. But, all these conventional methods are rarely used because they are time consuming, not cost effective & provide poor cleaning results & also create environmental pollution. Nowadays, water sand blasting by high pressure waterjet pump has got wide acceptance in the field of surface preparation as well as in paint removal & rust Removal. In water sandblasting, an abrasive material is mixed with the waterjet to create an abrasive spray. This abrasive spray is blasted on the surface, which breaks away small pieces of undesirable coating corrosion or other undesirable substances to create the desired metal finish, perfect for recoating. Water sand blaster is widely used in engineering, heavy engineering, fabrication, construction and many other industries for different applications.HOW WATER SANDBLASTING WORKS?Start the high pressure system and adjust the water flow and system pressure with your nozzle selection, pump RPM and Regulating Unloader setting. Open the trigger on gun to assure system is operating properly.Place the sand induction probe in the sand supply container. With the trigger on the gun open, adjust the small valve on the mixing head. The adjustment creates a vacuum in the sand hose line and starts the flow of sand. The pressure washer sandblaster should be approximately 12 to 15 inches away from the work surface when the trigger is opened and the water sandblasting operation begins. The angle of attack and distance from the work surface may be varied to provide the best work speed, while still maintaining the greatest amount of impact energy. For optimum performance the sand inlet hose should not exceed 25 feet.When the water sand blasting unit is operating efficiently, there will be a smooth and continuous flow of sand through the nozzle. The amount of sand flow is directly related to the vacuum created in mixing nozzle. The intensity of the vacuum is dependent upon the liquid velocity of the water.The pressure and flow rate through the spray nozzle are the factors that determine the liquid velocity, amount of vacuum and rate of sand flow.If the spray nozzle is chosen to give the maximum pressure and flow rate possible for the pump, the rate of sand flow will also be at maximum. Total vacuum seal and maximum swirl velocity are obtained at 5º spray nozzle.
, Wet Blast
, Wet Sandblasting